- Category
-
- Nozzles 18
- Nozzle Holders 19
- Nozzle Accessories 14
Nozzles, Holders & Accessories
Shop By
Shopping Options
-
ASJ Deflector Nozzle The ASJ Deflector manufactured by Arag in Italy, produces a wide angled spray pattern of 140 degrees commonly used for band spraying and also widely used in small Amenity and Lawn Tractor sprayers. They supply big droplets, thus reducing drift especially at low working pressures of 1-2 bars. Learn More
-
Hypro Gaurdian Air (Amnistar) Nozzles Guardian AIR™ nozzles produce smaller droplets than other air-induction nozzles, this means more droplets and better spray coverage. They offer a balance of excellent target coverage with reduced spray drift that can be fine tuned by the user. Guardian AIR™ nozzles are suitable for a wide range of crop spraying applications in several different sizes/colours. Learn More
-
Hardi ISO LD-110 LowDrift nozzles are fitted with a restrictor which reduces the number of fine droplets compared to the standard nozzle.This makes the droplets of LowDrift nozzle less sensitive to wind. Learn More
-
Hardi ISO MINIDRIFT air inclusion nozzles. These nozzles provide coarse atomisation, as they are fitted with a venturi, which creates a negative pressure in the nozzle and causes air to flow in through the side holes. The mix of air and spray liquid generates the coarser atomisation and results in droplets being less sensitive to wind. Learn More
-
This calibration chart allows you to select you nozzles, pressure, speed and litres per hectare. Is is a very easy to use and essential tool for any spraying operator. Learn More
-
Berthoud Single Nozzle Holder Diameter 25mm - Spiggot 10mm Part Number: 218892 Pack of 1 Learn More
-
Berthoud Single Nozzle Holder - Screw Type Diameter 25mm - Spiggot 7mm Part Number: 269261 Pack of 1 Learn More
-
Berthoud Quadrix Nozzle Holder 10mm spiggot 25mm Diameter Part Number: 216419S Learn More
-
This is half of a triple Hardi Nozzle Body Holder HA334926 Learn More
-
• Steady 110° jet • Working Pressure of 1.5 bar - 7 bar Learn More
-
• Steady 110° jet • Working Pressure of 1.5 bar - 7 bar Learn More
-
• 110° spray angle. • Drift Reduction Nozzle Learn More
-
• 110° spray angle. • Drift Reduction Nozzle Learn More
-
110° Hardi flat fan nozzles. Learn More
-
BSP sizes are based on the pipe bore (thread). Metric sizes are the external diameter of pipe. Learn More
-
BSP sizes are based on the pipe bore (thread). Metric sizes are the external diameter of pipe. Learn More
-
BSP sizes are based on the pipe bore (thread). Metric sizes are the external diameter of pipe. Learn More
-
This nozzle holder fits the standard Hardi plastic boom pipes. It will hold 3 Hardi snap-fit nozzles. It can be turned to choose the correct nozzle.HA725078
Learn More -
This is an Eezifit 3 Nozzle cap complete with seal. This will fit any Eezifit 3 nozzle body. Learn More